Skillets tend not to be very flat and change shape in the heat.This problem was fixed by using a skillet. The Sparkfun guys said that even with a cheap commercial reflow oven, some of their components with plastic housings (a USB type B connector from memory) would melt.You'll know when you really need to address the issues you brought up. In my experience, components are pretty darn robust all things considered, and nothing beats the learning process of watching solder paste reflow on some old boards (and SMT components, if you have some to spare). I think if you're not trying to sell stuff and you're not working with sensitive components, no mods are required. I figured out "how much" through trial and error on a few spare boards. All you need is a sufficient blob of solder paste, surface tension really does 90% of the work if you don't put too much on. Get yourself a solder paste kit with a syringe and different tips, and play with those (I used this one from Celeritous: there's also a lead-free version). I pretty much eyeball it when I first do a board of a given type to see when different parts reflow based on the amount of solder paste I use, but it's all been pretty similar in my smallish projects.Īs far as templates/stencils go, I don't bother unless I have lots of fine-pitched ICs. Check your datasheets to make sure your components can handle whatever temperature your solder paste melts at, and for how long. I can't remember the specifics, but I usually give it roughly 90 seconds to come to a "warm-up" temperature, then jack it up to my final baking temperature (I think it spends about a minute or two in that phase). I have successfully reflowed many boards with different ICs and have never had an issue. I have used older toaster ovens, and they work just fine for hobbyist work, but if you're going to pick up a new one then spend the extra $10 or so to get convection. The convection bake mode is important, as it more evenly distributes the temperature in the oven which prevents hot spots from frying components or cold spots from forming cold solder joints. I just picked up a toaster oven with a convection bake mode, no mods at all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |